Dell PowerConnect 5424 Command Line Interface Guide

LACP Commands 243
LACP Commands
lacp system-priority
The lacp system-priority Global Configuration mode command configures the system priority. Use
the no form of this command to reset to default.
Syntax
• lacp system-priority value
• no lacp system-priority
• value — Value of the priority. (Range: 1 - 65535)
Default Configuration
The default system priority value is 1.
Command Mode
Global Configuration mode.
User Guidelines
• There are no user guidelines for this command.
Example
The following example configures the system priority to 120.
lacp port-priority
The lacp port-priority Interface Configuration mode command configures the priority value for
physical ports. Use the no form of this command to reset to default priority value.
Syntax
• lacp port-priority value
•no lacp port-priority
• value — Port priority value. (Range: 1 - 65535)
Console (config)# lacp system-priority 120
5400_CLI.book Page 243 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation