36 Command Groups
Address Table Commands
password Specifies a password on a line. Line Configuration
enable password Sets a local password to control access to normal and
privilege levels.
Global
Configuration
username Establishes a username-based authentication system. Global
Configuration
show users accounts Displays information about the local user database. Privileged User
EXEC
Command Group Description Access Mode
bridge address Adds a static MAC-layer station source address to the
bridge table.
VLAN
Configuration
bridge multicast filtering Enables filtering of Multicast addresses. Global
Configuration
bridge multicast address Registers MAC-layer Multicast addresses to the bridge
table, and adds static ports to the group.
VLAN
Configuration
bridge multicast forbidden
address
Forbids adding a specific Multicast address to specific
ports.
VLAN
Configuration
bridge multicast
unregistered
Configures the forwarding state of unregistered multicast
addresses.
Interface
Configuration
bridge multicast forward-all Enables forwarding of all Multicast frames on a port. VLAN
Configuration
bridge multicast forbidden
forward-all
Enables forbidding forwarding of all Multicast frames to
a port.
VLAN
Configuration
bridge aging-time Sets the address table aging time. Global
Configuration
clear bridge Removes any learned entries from the forwarding
database.
Privileged User
EXEC
port security Disables new address learning on an interface. Interface
Configuration
port security routed secure-
address
Adds MAC-layer secure addresses to a routed port. Interface
Configuration
show bridge address-table Displays dynamically created entries in the
bridge-forwarding database.
Privileged User
EXEC
show bridge address-table
static
Displays statically created entries in the
bridge-forwarding database
.
Privileged User
EXEC
5400_CLI.book Page 36 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
