Dell PowerConnect 5424 Command Line Interface Guide

Command Groups 43
IPv6 Addressing Commands
Command Group Description Access Mode
ipv6 enable Enables IPv6 processing on an interface. Interface Configuration
ipv6 address autoconfig Enables automatic configuration of IPv6 addresses
using stateless autoconfiguration on an interface.
Interface Configuration
ipv6 icmp error-interval Configures the rate limit interval and bucket size
parameters for IPv6 ICMP error messages.
Global Configuration
show ipv6 icmp error-
interval
Displays the IPv6 ICMP error interval setting Privileged EXEC
ipv6 address Configures an IPv6 address for an interface. Interface Configuration
ipv6 address link-local Configures an IPv6 link-local address for an interface. Interface Configuration
ipv6 unreachables Enables the generation of Internet Control Message
Protocol for IPv6 (ICMPv6) unreachable messages for
any packets arriving on a specified interface.
Interface Configuration
ipv6 default-gateway Defines an IPv6 default gateway. Global Configuration
ipv6 mld join-group Configures Multicast Listener Discovery (MLD)
reporting for a specified group.
Interface Configuration
ipv6 mld version Changes the Multicast Listener Discovery Protocol
(MLD) version.
Interface Configuration
show ipv6 interface Displays the usability status of interfaces configured
for IPv6.
Privileged EXEC
show ipv6 route Displays the current state of the IPv6 routing table. Privileged EXEC
ipv6 nd dad attempts Configures the number of consecutive neighbor
solicitation messages that are sent on an interface
while duplicate address detection is performed on the
unicast IPv6 addresses of the interface.
Interface Configuration
ipv6 host Defines a static host name-to-address mapping in the
host name cache.
Global Configuration
ipv6 neighbor Configures a static entry in the IPv6 neighbor
discovery cache.
Global Configuration
ipv6 set mtu Sets the MTU size of IPv6 packets sent on an
interface.
Privileged EXEC
show ipv6 neighbors Displays IPv6 neighbor discovery cache informatio. Privileged EXEC
clear ipv6 neighbors Deletes all entries in the IPv6 neighbor discovery
cache, except static entries.
Privileged EXEC
5400_CLI.book Page 43 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation