Port Channel Commands 281
Port Channel Commands
interface port-channel
The interface port-channel Global Configuration mode command enters the Interface
Configuration mode of a specific port-channel.
Syntax
•
interface port-channel
port-channel-number
•
port-channel-number
— A valid port-channel trunk index.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
• Eight aggregated links can be defined with up to 8 member ports per port channel.Turning off
auto-negotiation of an aggregate link may, under some circumstances, make it non-operational.
If
the other side has auto-negotiation turned on, it may re-synchronize all members of the
aggregated link to half-duplex operation, and may, as per the standards, set them all to inactive.
Example
The following example enters the context of port-channel number 1.
interface range port-channel
The interface range port-channel Global Configuration mode command enters the Interface
Configuration mode to configure multiple port-channels.
Console (config)# interface port-channel 1
5400_CLI.book Page 281 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
