IGMP Snooping Commands 197
ip igmp snooping host-time-out
The ip igmp snooping host-time-out Interface Configuration mode command configures the host-time-
out. If an IGMP report for a Multicast group was not received for a host-time-out period from a specific
port, this port is deleted from the member list of that Multicast group. Use the no form of this command
to reset to default host-time-out.
Syntax
•
ip igmp snooping host-time-out
time-out
• no ip igmp snooping host-time-out
•
time-out
— Host timeout in seconds. (Range: 60 - 2147483647)
Default Configuration
The default host-time-out is 260 seconds.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
• The timeout should be at least greater than 2*query_interval+max_response_time of the IGMP
router.
Example
The following example configures the host timeout to 300 seconds.
ip igmp snooping mrouter-time-out
The ip igmp snooping mrouter-time-out Interface Configuration mode command configures the
mrouter-time-out. The mrouter-time-out command is used for setting the aging-out time after Multicast
router ports are automatically learned. Use the no form of this command to configure the default
mrouter-time-out.
Syntax
•
ip igmp snooping mrouter-time-out
time-out
• no ip igmp snooping mrouter-time-out
•
time-out
— mrouter timeout in seconds (Range: 1 - 2147483647)
Console (config)# interface vlan 2
Console (config-if)# ip igmp snooping host-time-out 300
5400_CLI.book Page 197 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
