298 QoS Commands
Example
The following example configures port g5 to default trust state (CoS).
qos cos
The qos cos Interface Configuration mode command configures the default port CoS value. Use the no
form of this command to return to the default setting.
Syntax
•
qos cos
default-cos
• no qos cos
•
default-cos
— Specifies the default CoS value being assigned to the port. If the port is trusted and
the packet is untagged then the default CoS value becomes the CoS value. (Range: 0 - 7)
Default Configuration
Port CoS is 0.
Command Mode
Interface Configuration (Ethernet, port-channel) mode.
User Guidelines
• You can use the default value to assign a CoS value to all untagged packets entering the port.
Example
The following example configures port g5 default CoS value to 3.
show qos map
The show qos map User EXEC mode command displays all the QoS maps.(CHECK WITH MARY)
Syntax
•
show qos map
[
dscp-queue
]
•
dscp-queue
— Displays the DSCP to queue map.
Console (config)# interface ethernet g5
Console (config-if) qos trust
Console (config)# interface ethernet g5
Console (config-if) qos cos 3
5400_CLI.book Page 298 Wednesday, December 17, 2008 4:33 PM