Dell PowerConnect 5424 Command Line Interface Guide

Radius Commands 305
User Guidelines
• There are no user guidelines for this command.
Example
The following example configures the source IPv6 address used for communication with RADIUS
servers.
radius-server timeout
The radius-server timeout Global Configuration mode command sets the interval for which a device
waits for a server host to reply. Use the no form of this command to restore the default.
Syntax
• radius-server timeout timeout
• no radius-server timeout
• timeout — Specifies the timeout value in seconds. (Range: 1 - 30)
Default Configuration
The default value is 3 seconds.
Command Mode
Global Configuration mode.
User Guidelines
• There are no user guidelines for this command.
Example
The following example sets the interval for which a device waits for a server host to reply to 5 seconds.
Console (config)# radius-server source-ipv6 3156::98
Console (config)# radius-server timeout 5
5400_CLI.book Page 305 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation