50 Command Groups
SNMP Commands
show rmon events Displays the RMON event table. User EXEC
show rmon log Displays the RMON logging table. User EXEC
rmon table-size Configures the maximum RMON tables sizes. Global
Configuration
Command Group Description Access Mode
snmp-server community the community access string to permit access to SNMP
protocol.
Global
Configuration
snmp-server view Creates or update a view entry, Global
Configuration
snmp-server contact Sets up a system contact. Global
Configuration
snmp-server location Sets up the information on where the device is located. Global
Configuration
snmp-server enable traps Enables the switch to send SNMP traps or SNMP
notifications.
Global
Configuration
snmp-server trap
authentication
Enables the switch to send Simple Network
Management Protocol traps when authentication failed.
Global
Configuration
snmp-server host Specifies the recipient of Simple Network Management
Protocol notification operation,
Global
Configuration
snmp-server set Sets SNMP MIB value by the CLI. Global
Configuration
snmp-server group Configures a new Simple Network Management Protocol
(SNMP) group, or a table that maps
SNMP users to SNMP views.
Global
Configuration
snmp-server user Configure a new SNMP Version 3 user.
Global
Configuration
snmp-server v3-host Specifies the recipient of Simple
Network Management Protocol Version 3 notifications.
Global
Configuration
snmp-server engineID local Specifies the Simple Network Management Protocol
(SNMP) engineID on the local device.
Global
Configuration
show snmp engineid Displays the ID of the local Simple Network Management
Protocol (SNMP) engine
Privileged User
EXEC
show snmp Displays the SNMP status. Privileged User
EXEC
5400_CLI.book Page 50 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
