Dell PowerConnect 5424 Command Line Interface Guide

GVRP Commands 191
clear gvrp statistics
The clear gvrp statistics Privileged EXEC mode command clears all the GVRP statistics information.
Syntax
• clear gvrp statistics [ ethernet interface | port-channel port-channel-number ]
• interface — A valid Ethernet interface.
• port-channel-number — A valid port-channel trunk index.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
• There are no user guidelines for this command.
Example
The following example clears all the GVRP statistics information on port g8.
show gvrp configuration
The show gvrp configuration User EXEC mode command displays GVRP configuration information,
including timer values, whether GVRP and dynamic VLAN creation is enabled, and which ports are
running GVRP.
Syntax
• show gvrp configuration [ ethernet interface | port-channel port-channel-number ]
• interface — A valid Ethernet interface.
• port-channel-number — A valid port-channel trunk index.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode.
Console# clear gvrp statistics ethernet g8
5400_CLI.book Page 191 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation