IP Addressing Commands 225
Example
The following example defines an IPv6 default gateway.
show ipv6 interface
The show ipv6 interface
Privileged EXEC
mode command displays the usability status of interfaces
configured for IPv6.
Syntax
•
show ipv6 interface
[
ethernet
interface-number
|
vlan
vlan-id
|
port-channel
number
]
•
ethernet
interface-number
— Ethernet port number
•
vlan
vlan-id
— VLAN number
•
port-channel
number
— Port channel number
Default Configuration
Displays all IPv6 interfaces.
Command Mode
Privileged EXEC mode.
User Guidelines
• To display IPv6 neighbor discovery cache information, use the
show ipv6 neighbors
command in the
privileged EXEC mode.
Examples
The following examples displays the usability status of interfaces configured for IPv6.
Console(config-if)# ipv6 mld version 1
Console# show ipv6 interface
Interface IP addresses Type
---------- ----------------- -----
g2 7001::5668/64 [ANY] manual
g2 6001::1234/64 manual
g2 fe80::22/64 manual
g2 ff02::1 linklayer
g2 ff02::78 manual
5400_CLI.book Page 225 Wednesday, December 17, 2008 4:33 PM