Ethernet Configuration Commands 173
port storm-control include-multicast
The port storm-control include-multicast Interface Configuration (Ethernet) mode command enables
counting Multicast packets in the port storm-control broadcast rate command. Use the no form of this
command to disable counting Multicast packets.
Syntax
• port storm-control include-multicast [unknown-unicast]
• no port storm-control include-multicast
Count unknown Unicast packets.
Default Configuration
Disabled.
Command Modes
Interface Configuration (Ethernet) mode
User Guidelines
• To control Multicasts storms use the commands
port storm-control broadcast enable
and
port storm-
control broadcast rate
.
Example
The following example enables the counting of Multicast packets.
port storm-control broadcast enable
The port storm-control broadcast enable Interface Configuration mode command enables Broadcast
storm control. Use the no form of this command to disable Broadcast storm control.
Syntax
port storm-control broadcast enable
no port storm-control broadcast enable
Default Configuration
Broadcast storm control is disabled.
Command Modes
Interface Configuration (Ethernet) mode
Console# configure
Console(config)# port storm-control include-multicast
5400_CLI.book Page 173 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
