Dell PowerConnect 5424 Command Line Interface Guide

304 Radius Commands
radius-server source-ip
The radius-server source-ip Global Configuration mode command specifies the source IP address used
for communication with RADIUS servers. Use the no form of this command to return to the default.
Syntax
• radius-server source-ip source
• no radius source-server-ip source
• source — Specifies the source IP address.
Default Configuration
The default IP address is the outgoing IP interface.
Command Mode
Global Configuration mode.
User Guidelines
• There are no user guidelines for this command.
Example
The following example configures the source IP address used for communication with RADIUS servers
to 10.1.1.1.
radius-server source-ipv6
The radius-server source-ipv6 Global Configuration mode command specifies the source IPv6 address
used for the IPv6 communication with RADIUS servers. Use the no form of this command to return to
the default.
Syntax
• radius-server source-ipv6 source
• no radius-server source-ipv6 source
• source — Specifies the source IPv6 address.
Default Configuration
The default IP address is the outgoing IP interface.
Command Mode
Global Configuration mode.
Console (config)# radius-server source-ip 10.1.1.1
5400_CLI.book Page 304 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation