Dell PowerConnect 5424 Command Line Interface Guide

iSCSI Commands 239
Default Configuration
256 connections.
Command Mode
Global Configuration mode.
User Guidelines
• The new setting takes affect after reset.
• The amount of iSCSI connections affects other system features: iSCSI aware, DHCP snooping and
ACL rules use the same system resource. When increasing the number of iSCSI connections the other
application rules (DHCP snooping or ACL) can be removed after reset.
• If more than the Max Connections (default 256) connections exist in Network, the connectons still
receive their QoS profile but only the Max Connections number will be displayed.
Example
The following example sets the maximum number of iSCSI connections to 100.
show iscsi
The show iscsi Privileged EXEC mode command displays the iSCSI settings.
Syntax
• show iscsi
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
There are no user guidelines for this command.
Console (config)# iscsi max tcp connections 100
5400_CLI.book Page 239 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation