EasyManuals Logo

Dell PowerConnect 5424 Command Line Interface Guide

Dell PowerConnect 5424
512 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #257 background imageLoading...
Page #257 background image
LLDP Commands 257
Syntax
lldp tx-delay
seconds
no lldp tx-delay
Parameters
seconds
Specifies the delay in seconds between successive LLDP frame transmissions initiated
by value/status changes in the LLDP local systems MIB. (Range 1 - 8192 seconds)
Default Configuration
The default value is 2 seconds.
Command Modes
Global Configuration mode.
Usage Guidelines
It is recommended that the TxDelay would be less than 0.25 of the LLDP timer interval.
Examples
The following example specifies the delay between successive LLDP frame transmissions initiated by
value/status changes in the LLDP local systems MIB to 10 seconds.
lldp optional-tlv
The lldp optional-tlv Interface Configuration mode command specifies which optional TLVs from the
basic set should be transmitted. Use the no form of this command to revert to the default setting.
Syntax
lldp optional-tlv
tlv1
[
tlv2
tlv5
]
no lldp optional-tlv
tlv
Specifies TLV that should be included. Available optional TLVs are:
port-desc, sys-name,
sys-desc, sys-cap, 802.3-mac-phy.
Default Configuration
No optional TLV is transmitted.
Command Modes
Interface Configuration (Ethernet) mode.
Console (config) # lldp tx-delay 10
5400_CLI.book Page 257 Wednesday, December 17, 2008 4:33 PM

Table of Contents

Other manuals for Dell PowerConnect 5424

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell PowerConnect 5424 and is the answer not in the manual?

Dell PowerConnect 5424 Specifications

General IconGeneral
Ports24 x 10/100/1000Base-T
Switching Capacity48 Gbps
Forwarding Rate35.7 Mpps
VLAN SupportYes
Rack MountableYes
Power SupplyInternal
MAC Address Table Size8K entries
RAM128 MB
Flash Memory16 MB
Voltage Required100-240V AC
ManagementWeb, CLI, SNMP
Operating Temperature0°C to 45°C
Storage Temperature-20°C to 70°C
Humidity10% to 90% (non-condensing)
Standards ComplianceIEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management ProtocolSNMP, RMON, Telnet
FeaturesQoS, VLAN, Link Aggregation

Related product manuals