Dell PowerConnect 5424 Command Line Interface Guide

416 System Management
Syntax
• show version
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode.
User Guidelines
• There are no user guidelines for this command.
Example
The following example displays a system version (this version number is only for demonstration
purposes).
asset-tag
The asset-tag Global Configuration mode command specifies the device asset tag. Use the no form of
the command to remove the existing asset tag.
Syntax
• asset-tag tag
• no asset-tag
• tag — The device asset tag. (Range: 1- 16 characters)
Default Configuration
This command has no default configuration. No asset tag is defined by default.
Command Mode
Global Configuration mode.
Console# show version
SW version 1.0.0.1 ( date Jun 26 2008 time 19:08:13 )
Boot version ( date time )
HW version 1.0.0
console#
5400_CLI.book Page 416 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation