Dell PowerConnect 5424 Command Line Interface Guide

492 802.1x Commands
Examples
The following example uses the aaa authentication dot1x default command with no authentication.
dot1x system-auth-control
The dot1x system-auth-control Global Configuration mode command enables 802.1x globally. Use the
no form of this command to disable 802.1x globally.
Syntax
• dot1x system-auth-control
• no dot1x system-auth-control
• This command has no arguments or keywords.
Default Configuration
802.1x globally disabled.
Command Modes
Global Configuration mode.
User Guidelines
• There are no user guidelines for this command.
Examples
The following example enables 802.1x globally.
dot1x port-control
The dot1x port-control Interface Configuration mode command enables manual control of the
authorization state of the port. Use the no form of this command to return to the default setting.
Console (config)# aaa authentication dot1x default none
Console(config)# dot1x system-auth-control
5400_CLI.book Page 492 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation