Dell PowerConnect 5424 Command Line Interface Guide

VLAN Commands 467
Example
The following example displays protocols-groups information.
show interfaces switchport
The show interfaces switchport Privileged EXEC mode command displays switchport configuration.
Syntax
• show interfaces switchport {ethernet interface | port-channel port-channel-number }
• Interface — Specific interface, such as ethernet g8.
• port-channel-number — Valid port-channel trunk index.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
• There are no user guidelines for this command.
Console# show vlan protocols-groups
Encapsulation Protocol Group Id
------------- -------- --------
ethernet 08 00 213
ethernet 08 06 213
ethernet 81 37 312
ethernet 81 38 312
rfc1042 08 00 213
rfc1042 08 06 213
5400_CLI.book Page 467 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation