SNMP Commands 337
•
md5-des-keys
— Concatenated hexadecimal string of the MD5 key (MSB) and the privacy key
(LSB). If authentication is only required you should enter 16 bytes, if authentication and privacy
are required you should enter 32 bytes. Each byte in hexadecimal character strings is two
hexadecimal digits. Each byte can be separated by a period or colon. (Range: 16 - 32 characters)
•
auth
-
sha-key
— The HMAC-SHA-96 authentication level. The user should enter authentication
and privacy keys.
•
sha-des-keys
— Concatenated hexadecimal string of the SHA key (MSB) and the privacy key
(LSB). If authentication is only required you should enter 20 bytes, if authentication and privacy
are required you should enter 36 bytes. Each byte in hexadecimal character strings is two
hexadecimal digits. Each byte can be separated by a period or colon. (Range: 20 - 36 characters)
Default Configuration
No group entry exists.
Command Mode
Global Configuration mode.
User Guidelines
•If
auth-md5
or
auth-sha
is specified, both authentication and privacy are enabled for the user.
When you enter a
show running-config
command, you will not see a line for this user. To see if
this user has been added to the configuration, type the
show snmp user
command.
An SNMP EngineID should be defined in order to add users to the device.
Changing or removing the value of snmpEngineID deletes the SNMPv3 users database.
Example
The following example configures a new SNMP Version 3 user.
snmp-server v3-host
The snmp-server v3-host Global Configuration mode command specifies the recipient of Simple
Network Management Protocol Version 3 notifications. Use the no form of this command to remove the
specified host.
Console (config)# snmp-server user
5400_CLI.book Page 337 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
