Tunnel 433
Tunnel
interface tunnel
The interface tunnel Global Configuration
mode
command enters tunnel interface configuration
mode.
Syntax
•
interface tunnel
number
•
number
— Tunnel index. (Range: 1)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
• There are no user guidelines for this command.
Example
The following example enters tunnel interface configuration mode to configure tunnel 1.
tunnel mode ipv6ip
The tunnel mode ipv6ip Interface Tunnel Configuration
mode
command configures an IPv6
transition mechanism global support mode. Use the no form of this command to remove the IPv6
transition mechanism.
Console (config)# interface tunnel 1
Console (config-tunnel)#
5400_CLI.book Page 433 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
