Dell PowerConnect 5424 Command Line Interface Guide

SNMP Commands 341
Example
The following example specifies the Simple Network Management Protocol (SNMP) engineID on the
local device.
show snmp engineid
The show snmp engineID Privileged EXEC mode command displays the ID of the local Simple Network
Management Protocol (SNMP) engine.
Syntax
• show snmp engineID
Default Setting
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
• There are no user guidelines for this command.
Example
The following example displays the SNMP engine ID.
show snmp
The show snmp Privileged EXEC mode command displays the SNMP status.
Syntax
•show snmp
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
Console(config) # snmp-server engineID local default
Console# show snmp engineID
Local SNMP engineID: 08009009020C0B099C075878
5400_CLI.book Page 341 Wednesday, December 17, 2008 4:33 PM

Dell PowerConnect 5424 Specifications

General

Ports	24 x 10/100/1000Base-T
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
VLAN Support	Yes
Rack Mountable	Yes
Power Supply	Internal
MAC Address Table Size	8K entries
RAM	128 MB
Flash Memory	16 MB
Voltage Required	100-240V AC
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Humidity	10% to 90% (non-condensing)
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Remote Management Protocol	SNMP, RMON, Telnet
Features	QoS, VLAN, Link Aggregation