40 Command Groups
description Adds a description to an interface. Interface
Configuration
speed Configures the speed of a given Ethernet interface
when not using auto-negotiation.
Interface
Configuration
duplex Configures the full/half duplex operation of a given
Ethernet interface when not using auto-negotiation.
Interface
Configuration
negotiation Enables auto-negotiation operation for the speed and
duplex parameters of a given interface.
Interface
Configuration
flowcontrol Configures the Flow Control on a given interface. Interface
Configuration
system flowcontrol Enables flow control on cascade ports. Interface
Configuration
mdix Enables automatic crossover on a given interface. Interface
Configuration
back-pressure Enables Back Pressure on a given interface. Interface
Configuration
port jumbo-frame Enables jumbo frames for the device. Global
Configuration
clear counters Clears statistics on an interface. User EXEC
set interface active Reactivates an interface that was suspended by the
system.
Privileged User
EXEC
show interfaces
configuration
Displays the configuration for all configured
interfaces.
User EXEC
show interfaces status Displays the status for all configured interfaces. User EXEC
show interfaces description Displays the description for all configured interfaces. User EXEC
show interfaces counters Displays traffic seen by the physical interface. User EXEC
show ports jumbo-frame Displays the jumbo frames configuration. User EXEC
port storm-control include-
multicast
Enables the device to count Multicast packets. Global
Configuration
port storm-control
broadcast enable
Enables Broadcast storm control. Interface
Configuration
port storm-control
broadcast rate
Configures the maximum Broadcast rate. Interface
Configuration
show ports storm-control Displays the storm control configuration. Privileged User
EXEC
show system flowcontrol Displays the flow control state on cascade ports. Privileged User
EXEC
5400_CLI.book Page 40 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
