402 System Management
User Guidelines
Press
Esc
to stop pinging. Following are sample results of the
ping
command:
•
Destination (host/network) unreachable
— The gateway for this destination indicates an
unreachable destination.
•
Destination does not respond
— If the host does not respond, a “no answer from host” appears in
ten seconds.
The IPv6Z address format: <
ipv6-link-local-address
>%<
interface-name
>
–
interface-name
—
vlan
<
integer
> |
ch
<
integer
> |
isatap
<
integer
> | <
physical-port-name
> | 0
–
integer
— <
decimal-number
> | <
integer
><
decimal-number
>
–
decimal-number
— 0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9
–
physical-port-name
— Designated port number, for example g1.
When using the ping ipv6 command to check network connectivity of a directly attached host using its
link local address, the egress interface may be specified in the IPv6Z format. If the egress interface is
not specified, the default interface is selected. Specifying interface zone=0 is the same as not defining
an egress interface.
When using the ping ipv6 command with a multicast address, the information displayed is taken from
all received echo responses.
Examples
The following example displays a ping to IP address 10.1.1.1.
Console> ping 10.1.1.1
Pinging 10.1.1.1 with 64 bytes of data:
64 bytes from 10.1.1.1: icmp_seq=0. time=11 ms
64 bytes from 10.1.1.1: icmp_seq=1. time=8 ms
64 bytes from 10.1.1.1: icmp_seq=2. time=8 ms
64 bytes from 10.1.1.1: icmp_seq=3. time=7 ms
----10.1.1.1 PING Statistics----
4 packets transmitted, 4 packets received, 0% packet loss
round-trip (ms) min/avg/max = 7/8/11
5400_CLI.book Page 402 Wednesday, December 17, 2008 4:33 PM
To Next Page
Loading...
Need help?
General
