EDIUS — User Reference Guide 229
Batch Capturing
2. Playback the source to be captured and set the In and Out point(s) as
desired.
Note If an Out point is set at a timecode before the In point, the In, Out and Dura-
tion timecodes in the Player window are colored in red text. The range in red
text will not be captured. See Figure 211 for an example.
Figure 211. Out Point Set Before In Point on Timeline
3. Click the Add to Batch Capture List button (click the button icon not the list
button) to add the selected clip to the batch capture list.
Note Pressing [CTRL]+[B] on the keyboard also adds clips to the batch capture
list.
4. Repeat steps 2 and 3 for all clips you wish to capture.
Note To capture additional clips from the same source, clear the previous In and
Out points after adding the clip to the batch capture list.
5. After adding all desired clips to the batch capture list, click the list
button (V) of the
Add to Batch Capture List button and select “Batch
Capture” from the menu. See Figure 210.
Note You may also select Capture>Batch Capture on the Preview window to open
the batch capture list.
The batch capture dialog in Figure 212 appears.
Figure 212. Batch Capture Dialog
To Next Page
Loading...
Need help?
General