GRASS VALLEY EDIUS VERSION 5.1 User Manual

230 EDIUS — User Reference Guide
Section 3 — Capturing and Importing Clips and Stills
Note If a reel name was set while defining Input Settings, it will be displayed in the
Batch Capture dialog. See Setting Reel Name on page 211 for more informa-
tion.
6. De-select (remove the check mark) any clips you may want to exclude
from the batch capture.
Note As clips are added to the batch capture list, they are automatically selected
for inclusion in the batch capture.
7. Click the Show Setup Dialog button to verify the capture settings.
Refer to Capture Settings on page 207 for a discussion of appropriate
batch capture settings.
8. Click the Capture button to begin capturing the clips in the batch capture
list.
The Batch Capture dialog (see Figure 213 for an example) shows the batch
capture operation in progress.
Figure 213. Batch Capture in Progress
9. While capturing a clip, clicking the Set Mark button will place a Clip
marker at the current timecode location and the message “marker set to
00:00:00;00” (00:00:00;00 is replaced by the actual clip timecode) is
displayed for five seconds. See Sequence and Clip Markers on page 316 for
more information on Clip markers.
Note The total number of Clip markers set during a batch capture operation is also
displayed in the Batch Capture dialog.
10. When the batch capture is complete, click the Close button to exit the
Batch Capture dialog.

GRASS VALLEY EDIUS VERSION 5.1 Specifications

General

Brand	GRASS VALLEY
Model	EDIUS VERSION 5.1
Category	Software
Language	English