Installing iLink
3-13
3
iControl DC
Installing iLink
iLink provides an efficient, one-stop interconnect point between car and hoistway wiring and
iControl. The serial link between iLink and iControl allows the bulk of the travelling cable to be
reduced. The illustration below shows a view of iLink circuitry with the cover removed.
Figure 3.1 iLink Circuitry and Wiring
This section describes:
• iLink enclosure installation
• Door signal wiring
•Cartop inspection wiring
• Cartop safety wiring
• Loadweigher wiring
• Door operator wiring
The wiring between the iLand landing system and iLink was described earlier. (Please refer to
“Cabling Connections” on page 3-11.)
To Next Page
Loading...