Configuration Tabs - Security
10-57
10
iControl DC
Remote Security
Remote Security settings configure
the interface to an independent secu-
rity management system.
• Select the system type in the
Security Type dropdown menu.
Credential Reader Options
This screen is used to identify essential information associated with each card reader.
Credential swipe timer: If the call is registered first, time allotted for a valid security
credential to be presented after being prompted by the kiosk display. If the credential is pre-
sented first, time allotted to register the call.
Credential Reader Definition: Information used by iControl to identify the security
reader:
• Reader ID: Numerical identifier for a specific reader.
• Floor: The floor on which the reader is located.
• Door Side: The door, front or rear, associated with the reader location.
• Kiosk ID: Numerical identifier for the kiosk associated with the reader.
To Next Page
Loading...
Need help?
General