System Configuration tab
10-13
10
iControl DC
Dispatching - Configurations
These controls determine how four types of pre-programmed dispatching configurations and
the Dispatching engine are selected to be active. Up to eight configurations of each type can be
programmed.
• Dispatching configuration: The currently active configuration and Dispatching engine can
be selected manually (Manual) or by a timer schedule (Timed).
• Configurations:
• Manual: When Dispatching configuration is set to manual, you can select which con-
figuration and which Dispatching engine is active in the Manual column. When a set-
ting is changed, it becomes active after you Send it to the controller.
• Timed: Select Timed to have the currently active configurations and/or Dispatching
engine determined via timer table. Please refer to “Configuration Tabs - Timer Tables”
on page 10-70.
• Active: The dispatching configurations and Dispatching engine that are currently
active are shown in the “Active” column. The four types of dispatching configurations
are:
• Hall Call Eligibility Parking
• Parking Eligibility Mode of Operation
The configurations you are selecting here are configured on the screen tabs of the same name.
• Dispatching engine: If DBD (Destination Based Dispatching) has been enabled, the Dis-
patching > Configurations tab allows DBD to be selected manually or via timer table.
Hall Call Eligibility Configurations
1 2 3 4 5 6 7 8
Parking Configurations
1 2 3 4 5 6 7 8
Dispatching Configuration
Parking Eligibility Configurations
1 2 3 4 5 6 7 8
1
5
7
Mode of Operation Configurations
1 2 3 4 5 6 7 8
3
To Next Page
Loading...