9-1
About this Section
This section contains detailed information about:
• Selecting Controller view:
• Controller View Windows and tabs: A complete list of iView windows and tabs, and infor-
mation about the parameters on each.
Selecting Controller View
iView is used to view and adjust the Controller and System parameters. iView is divided into
two main sections:
• Controller View - used to view and adjust the controller parameters, e.g., Brake, Drive,
Pattern, Car Operation, etc. When iView first connects to an iController, the Controller
view is displayed.
• System View - used to view and adjust the System parameters, e.g., Dispatching, Parking,
Emergency Power, Security, etc. When iView is connected to a central dispatcher (iCen-
tral), the Controller and System buttons are missing and System view is always displayed.
Please refer to “Selecting System View” on page 10-1.
To select Controller view, click the Controller view button at the top of the iView screen.
iView - Controller View
To Next Page
Loading...