Configuration Tabs - Security
10-55
10
iControl DC
2. Select the floor(s) and call types as previously described (Please refer to “Car Calls - Con-
figuration” on page 10-51).
3. In the dialog that appears, select the COP (front or rear) and the passcode (COP buttons
that must be pressed).
4. Click OK.
5. If you make an entry error, click Clear and then re-enter the numbers.
Car Calls - Passcodes - Passenger
This tab allows you to assign per-passenger car call enable passcodes (passcodes are entered
using COP buttons). To program a Passenger Passcode:
• Click the Add button. The Passenger Properties dialog is displayed.
•Enter the Name.
• Enter the Destinations Allowed by clicking the desired floors, front and/or rear. Or click
and drag to select multiple floors and then click Select or Deselect.
To Next Page
Loading...
Need help?
General