Troubleshooting
6-42 Manual # 42-02-7223
Hall Call Service Enabled
Description: Car is accepting hall calls (iBox IN GROUP indicator is On). See also, Hall Call Service Disabled.
Heat Detectors Recall Activated, HEAT DETECTORS RECALL
Description: A heat detector input has been activated.
Car Reaction: A car parked at a floor will open its doors and shut down. A car in motion will proceed in cur-
rent direction to next available floor where heat detector is not tripped. If all heat detectors in current direc-
tion are tripped, car will reverse direction and proceed to first floor where heat detector is not tripped. If
again all heat detectors are tripped, car shall proceed to main fire recall floor. Once stopped at a floor car will
automatically open doors and shut down. Please refer to “Car Operation - Heat Detectors” on page 9-90.
Heat Detectors Recall Complete
Description: Indicates car has completed Heat Detectors Recall operation (reached a floor, doors fully open).
Car Reaction: Car remains shut down until all heat detector inputs have been deactivated (see Heat Detec-
tors Recall Deactivated).
Heat Detectors Recall Deactivated
Description: All heat detector inputs are deactivated.
Car Reaction: The car is allowed to run.
Heat Sensor Fault ‘n’ (n = 2 to 4)
Description: Not currently used.
Hoistway Access Disabled, HA INSP. DISABLED
Description: Hoistway access inspection operation has been disabled.
Car Reaction: The car cannot be run on hoistway access inspection operation.
Troubleshooting:
1. Check for any car status that might prevent hoistway access inspection operation, e.g. earthquake.
2. Check for the Stuck Inspection Input Fault.
3. Check all inspection buttons (Enable, Up, Down) and verify that none are stuck in the ON position.
Hoistway Access Enabled
Description: Hoistway access inspection operation which was previously disabled is now enabled.
Hoistway Access Inspection Operation, Hoistway Access Operation, Hoistway Access
Description: Car is on Hoistway access (enabled by the Hoistway access switch).
Car Reaction: If running, the car will make an emergency stop and is taken out of normal service. Under this
mode of operation, car can only be moved manually using the access key switches.
Troubleshooting:
1. Related inputs:
HoistwayAccess: Normally high
Hoistway Door Bypass, HOISTWAY DOOR BYPASS
The Hoistway Door Bypass switch on the iBox is in the Bypass position. (View-only on iView Safety screen,
enabled/disabled by MCE according to safety jurisdiction.) The ability to set this bypass must be enabled at
the factory and is only available if allowed by safety regulations in your area. Check the iView Safety Config-
uration screen to see if the feature is enabled in your installation.
Description:
Car Reaction: The car is placed in Inspection mode. To move the car, you must place it in either cartop or
car panel inspection mode. No other modes of operation are allowed.
Table 6.3 iControl Messages
iControl Messages
To Next Page
Loading...