MCE iControl User Manual

LCD Display and Keypad
7-7
7
iControl DC
Table 7.1 Car Menu Parameters
Car Menu Parameters
Network Setup
There are three Ethernet ports on the iBox.
#1 is the Local Area Network connection used to connect Group and Elevator controllers to your Local Area
Network.
#2 is the MCE equipment connection used to interconnect Group and Elevator controllers for equipment
control purposes.
#3 is the PC Direct connection used to connect a PC directly to a Controller.
Network setup parameters allow IP information to be set for each of the ports. Additionally, an FTP User
Name and Password must be set here without which the File Transfer Protocol server may not be accessed.
There are many websites that are helpful in learning about TCP/IP.
To set the FTP User Name:
Enter a User Name that must be employed to access the FTP server.
To set the FTP User Password:
Enter a password that must be employed to access the FTP server.
To set the IP Name 1:
Enter a name for the #1 port. This is the peripherals port used for local area network connection, typically
for networked PCs running iView.
To set the IP Address 1:
Enter an address for the #1 port. Please refer to “System, LAN, & 3=PC TCP/IP Addresses” on page 7-9.
To set the IP Gateway 1:
Enter a gateway address for the #1 port. Please refer to “System, LAN, & 3=PC TCP/IP Addresses” on
page 7-9.
To set the IP Subnet Mask 1:
Enter a subnet mask address for the #1 port. Please refer to “System, LAN, & 3=PC TCP/IP Addresses” on
page 7-9.
To set the IP Name 2:
Enter a name for the #2 port. This is the system port used to connect to the hub that supports MCE control-
lers, serial hall call, etc.
To set the IP Address 2:
Enter an address for the #2 port. Please refer to “System, LAN, & 3=PC TCP/IP Addresses” on page 7-9.
To set the IP Gateway 2:
Enter a gateway address for the #2 port. Please refer to “System, LAN, & 3=PC TCP/IP Addresses” on
page 7-9.
To set the IP Subnet Mask 2:
Enter a subnet mask address for the #2 port. Please refer to “System, LAN, & 3=PC TCP/IP Addresses” on
page 7-9.
To set the IP Name 3:
Enter a name for the #3 port. This is the PC port meant for direct connection to a PC running iView using a
standard Ethernet cable and NO HUB.
To set the IP Address 3:
Address for the #3 port. Default at 192.168.193.1.
To set the IP Gateway 3:
Enter a gateway address for the #3 port. Please refer to “System, LAN, & 3=PC TCP/IP Addresses” on
page 7-9.
To set the IP Subnet Mask 3:
Enter a subnet mask address for the #3 port. Please refer to “System, LAN, & 3=PC TCP/IP Addresses” on
page 7-9.

MCE iControl Specifications

General

Brand	MCE
Model	iControl
Category	Controller
Language	English