MCE iControl User Manual

Configuration - Car Operation
9-79
9
iControl DC
• Bypass attendant service after “nnn” sec. Determines the delay from when a car is
assigned a CFSS call to when Attendant Service is bypassed and the car begins CFSS
mode.
• Bypass stop switch when car on CFSS recall: Enable if activation of the in-car Stop switch
should be ignored when the car is on commandeered operation.
• CFSS recall timeout: If the car has not answered the CFSS call before this timer times out,
the car becomes ineligible for CFSS calls, thereby allowing the call to be re-assigned to
another car. This timer also determines how long a recalled car will wait at the recall floor,
for activation of the in-car CFSS service switch or the registration of a car call if there is no
in-car CFSS service switch, before timing-out and returning to normal service.
In-car When a CFSS mode is selected, and after the recall is complete, these settings
determine how in-car operation is invoked and how the car behaves during in-car CFSS opera-
tion.
• Fire service and heat detector operation bypass In-car CFSS:
• Always: Specifies that In-car CFSS will always be bypassed when the car is in Fire Ser-
vice operation or Heat Detector operation.
• If fire is detected at the destination floor: Specifies that CFSS Recall will be bypassed
when the car is in Fire Service operation or Heat Detector operation if fire is detected
at the destination floor.
• Take car two floors below destination floor if fire is detected there: If the fire sensor on
the destination floor has been activated, take the car two floors below that floor.
• In-car visual indicator behavior: This setting defines how the in-car visual indicator (light,
etc.) will behave while in-car CFSS is active.
• Off: Indicator will remain off.
• Solid: Indicator will light solidly.
• Flash: Indicator will light intermittently (flash).
• In-car switch to activate CFSS:
• No switch: Select if there is no switch in car to activate CFSS. If selected, set “Resume
normal service xx seconds after answering last call” timer so that, after the period of
inactivity it defines has passed, the car will automatically exit CFSS operation.
• Constant Pressure (2-position switch): Select if there is a key or other constant-contact
switch in the car to invoke in-car CFSS operation.
• Momentary pressure (momentary switch): Select if there is a momentary-contact
switch (spring-loaded key or other) in the car to invoke in-car CFSS operation. If
selected, set the “Resume normal service xx seconds after answering last call” timer so
that, after the period of inactivity it defines has passed, the car will automatically exit
CFSS operation.
• Resume normal service after ‘xx’ seconds after answering last call: This determines how
long a recalled car will wait after answering the last call before timing-out and returning to
normal service.
• Permit in-car activation without recall first: If selected, in-car CFSS may be activated by an
in-car switch without first initiating and completing a recall phase.
• Cancel remaining car calls after answering a car call: If enabled, after the first CFSS car
call is answered, remaining calls are automatically canceled. Limits CFSS calls to one-at-a-
time.

MCE iControl Specifications

General

Brand	MCE
Model	iControl
Category	Controller
Language	English