iView - Controller View
9-98 Manual # 42-02-7223
General
• Car assignment tone: Tone used to signal that the car is assigned a special access call.
• Tone delay: Delay between car assignment and tone broadcast.
• Tone repeats: Number of times the car assignment tone will repeat.
• Destinations announcement
• Announce all destinations: Announce all destinations the car is to serve.
• Announce all destinations only with special access call at source floor: Announce all
destinations only when one or more of the calls to be served is special access.
• Announce only special access destinations: Announce only special access destinations
to be served by the car.
Hall Fixtures
• Destinations:
• Flash destinations: If checked, all destinations displayed on hall fixtures will flash
when the car approaches the Source floor where the destinations were registered.
• Display destinations:
• Upon assignment: Display hall fixture destinations when they are assigned.
• At slow down: Display destinations when the car approaches a DBD source floor.
Use this setting to minimize hitchhiker rider effect.
• Clear destinations:
• When doors are fully open: Clear the hall fixture destinations when the doors are
fully open. Use this setting to minimize hitchhiker rider effect.
• When doors start to close: Clear hall fixture destinations when doors start to close.
• When doors are fully closed: Clear hall fixture destinations when doors fully close.
• Car ID display:
• Display car ID on LCD fixtures: When checked, the car ID is displayed on LCD hall fix-
tures in the absence of destinations. Otherwise, a fixture dip switch determines what to
display (PI or car ID).
• Light up car ID: Specifies when to light up the car ID on the hall fixture.
•Never
• When there is a demand
•End of run
• Flash car ID at slow down: Specifies that the Car ID should be flashed. The car ID is
flashed for a predetermined time and then will remain on or be extinguished depend-
ing on the setting of the “Light up car ID” parameter.
• Hall fixture at floor: Verifies the floors at which hall fixtures are installed. If there is no
hall fixture at a floor, destination announcements and car tone are made by the car fixture.
Click Select or Deselect and then click the appropriate floors (front and/or rear openings).
Car fixtures
• Flash destinations: When checked, destination car is approaching flashes on jamb fixture.
• Clear destinations: Determines when destination just served is removed from fixture:
• When doors are fully open: Clear destination when doors are fully open.
• When doors start to close: Clear destination when doors start to close.
• When the doors are fully closed: Clear destination when doors are fully closed.
• Display both front and rear destinations on car fixture(s): Specifies that both front and
rear destinations will be displayed on all door jamb fixtures.
To Next Page
Loading...
Need help?
General