Configuration - I/O Boards
9-147
9
iControl DC
• CFSS Calls - CFSS 2 Rear
• CFSS Call - CFSS 2 Rear Output (1 - 96): Outputs which can be used to drive the CFSS
2 Rear Call lights.
• Custom Outputs
• Toggle Out: The Toggle Output can be used to convert a steady state Custom Output to
a toggled output.
• Custom Output (1 - 20): Allows existing inputs, outputs and internal flags to be com-
bined in a custom logic equation which can then generate a custom output. Please refer
to “Configuration - Advanced - Custom Outputs” on page 9-165.
• Remote User Outputs
• Remote (01 - 32) Output: User programmable outputs. Please refer to “Configuration
Tabs - Remote Outputs” on page 10-74.
• Heat Detectors
• Heat Detectors Audible Signal: This normally low output is activated when heat detec-
tors are activated. It is used to operate audible indicator(s).
• Heat Detectors Visual Signal: This normally low output flashes when heat detectors
are activated. It is used to operate visual indicator(s).
• Heat Detectors Recall Complete: This normally low output is activated when the car
has completed the Heat Detectors recall operation (reached a floor - doors are fully
open.
•Jail Operation
• Jail Master Mode Output: Activated when the car is operating in Jail Master Mode.
• Jail Secure Mode Output: Activated when the car is operating in Jail Secure Mode.
To Next Page
Loading...