iView - Controller View
9-150 Manual # 42-02-7223
Analog device configuration
•Sensing type
• Cross head deflection or rope tension sensing: Select if your load weigher provides an
analog signal based on deflection of the elevator cross head or the tension of the wire
ropes.
• Isolated platform displacement sensing (MCE): Select if your load weigher provides an
analog signal based on the compression of the pads under the isolated platform in the
car.
• Over load threshold (% of full load): When the weight in the car exceeds this threshold the
controller will consider the car to be in an over load condition. This value is typically 110%
to 115% of full load. Please refer to “Load Weigher Adjustment for Dispatching ” on page 4-
36.
• Heavy load threshold (% of full load): When the weight in the car exceeds this threshold
the controller will consider the car to be in a heavy load condition (used for hall call
bypass). Typically set from 80% to 90% of full load. Please refer to “Load Weigher Adjust-
ment for Dispatching ” on page 4-36.
• Light load threshold (% of full load): When the weight in the car is less than this threshold
the controller will consider the car to be in a light load condition. Typically this value is set
below 20% of full load. Please refer to “Load Weigher Adjustment for Dispatching ” on
page 4-36.
• Empty load threshold (% of full load): When the weight in the car is less than this thresh-
old the controller will consider the car to be empty. Typically less than 10% of full load.
Please refer to “Load Weigher Adjustment for Dispatching ” on page 4-36.
To Next Page
Loading...
Need help?
General