iView - System View
10-10 Manual # 42-02-7223
Making Settings Per-Car Verify the “Select a car to configure (1) drop-down box.
(There must also be a CFSS recall switch physically at the eligible Front or Rear door locations
on a floor selected to be eligible to initiate CFSS recall.)
Enable individual floor/recall location eligibility. You can make a selection in a few different
ways:
• Click in the door/hall call column in the desired floor row to enable or disable.
• Click and drag in a column to select multiple floors, then click the Select control to allow
calls or the Deselect control to restrict calls.
• Click in the column head (i.e., Front) to highlight the entire column (all floors), then use
the system-wide Select calls or Deselect calls controls.
Auto-select Preference Order This list defines the order in which CFSS calls are
assigned. The dispatcher selects the first available car in the priority list to assign a new call. If
there are no cars from the Priority Cars list available for a new CFSS call, the best available car
from the Non-priority Cars list shall be assigned the call. Initially, all cars are shown in the Non-
priority Cars list.
1. To move cars to the Priority Cars list, click to select cars in the Non-priority Cars list and
use the right arrow to move them to the Priority Cars list, as desired.
2. Click to select cars in the Priority Cars list and use the Up and Down buttons to place
them in the desired order. The highest on the list is selected first. If the first on the list
is not available, the next on the list is selected, and so fourth.
3. To remove a car from the Priority Cars list, click to select the car and use the left arrow
to move it to the Non-priority Cars list.
To Next Page
Loading...
Need help?
General