System Configuration tab
10-29
10
iControl DC
To program a Parking Eligibility configuration:
1. Select a Parking Eligibility configuration to edit/create (1 — 8).
2. Verify the car for which you want to set parking specifics.
3. If the car is not allowed to park when this configuration is active, select Not at all.
4. If the car is allowed to park only at a specific floor, set that floor, then click Edit to set
door behavior. In this instance, the elevator controller will be responsible for parking
the car — Parking tab configuration timers will not apply. Please refer to “Parking Con-
figurations” on page 10-22.
5. If the car is eligible to be parked according to the Parking configurations, select Per
parking configuration. The table below the selection will become active when Per park-
ing configuration is active. If you select this choice, also set the floors at which the car is
eligible to be parked and front, rear, or both doors access at that floor.
If a car is set to be eligible to be parked according to the Parking configurations, it must be made
eligible to park at some floor in the building (by selection in the table). It cannot be ineligible to
park at every floor and yet be included in Parking configurations. Please refer to “Parking” on
page 10-21.
6. Click Send to send changes to iControl.
7. Repeat for additional configurations or if this car is the designated Backup Dispatcher,
for additional cars.
To Next Page
Loading...