Configuration Tabs - Security
10-45
10
iControl DC
The Security > General > Status screen provides an overview of currently active security set-
tings.
• Master security:
• Active: Lights if any security mode is active.
• Hardware override: Lights if security has been overridden by a switch input.
• Software override: Lights if security has been overridden by a software selection.
• Activate Override button: Activates software security override. Button caption changes
to Deactivate Override when override is activated.
• Active configuration:
• Display: Indicates the currently active security configuration.
• Hardware configuration: Lights if configuration was activated by a hardware switch.
• Software configuration: Lights if configuration activated by software setting.
• Timed configuration: Lights if configuration activated by system timer created using
the Configuration > Timer Tables tab.
• Hall call security overrides:
• Enable 1: Lights if hall call enable 1 input is activated by a card reader or keypad, etc.
(System View > Configuration > System I/O - System tab - Hall call enable 1 inputs).
• Enable 2: Lights if hall call enable 2 input is activated by a card reader or keypad, etc.
(System View > Configuration > System I/O > System tab - Hall call enable 2 inputs).
• Car call security override:
• Master: Lights if the car’s Security Override Switch input is activated (Controller >
Configuration > I/O Boards > MIAC or COP - Security Override Switch input).
• Enable 1: Lights if a Car call enable 1 input is activated by a card reader or keypad, etc.
(Controller > Configuration > I/O Boards > MIAC or COP - Car call enable 1 inputs).
• Enable 2: Lights if a Car call enable 2 input is activated by a card reader or keypad, etc.
(Controller > Configuration > I/O Boards > MIAC or COP - Car call enable 2 inputs).
• Passcodes: Lights if the car’s Security Codes Override Switch input is activated (Con-
troller > Configuration > I/O Boards > MIAC or COP - Security Codes Override Switch
input).
•Remote security:
• Active: Lights if remote security is active (set on the Security > General tab).
• Last swiped card data: Shows the floor, door side and kiosk ID for the last swiped card.
To Next Page
Loading...