8-198 Phaser 7500 Printer Service Manual
Service Parts Disassembly
4. Disconnect all the wiring harness connectors that connect the MCU PWB to
the Motor Drive PWB.
5. Disconnect the 2 wiring harness connectors at the top of the PWB Chassis
Unit, squeeze and release the cable tie.
6. Disconnect the 2 wiring harness connectors at the bottom of the Drive Fan.
7. Release the wiring harness from the clamps (4) and the Harness Guide that
are attached to the PWB Chassis Unit.
8. Lift the clamp and remove the Flat Cable of the PWB Chassis Unit, and lift and
pull the Harness Guide together that it is attached to.
s7500-255
Dev Fan
Connector x2
Drive Fan
Release
Clamp x3
Guide
Clamp x1
Cable Tie
Connector x2
Cable Guide (Flat Cable)
To Next Page
Loading...
