(g) Align the rear end of the outer ferrule with the rear end of the inner ferrule.
Make sure that:
• The outer ferrule goes around the shield sleeve material
• The rear end of the outer ferrule does not extend farther than the rear end of the inner
ferrule
• The rear end of the outer ferrule is a maximum of 0.06 inch from the rear end of the
inner ferrule.
(h) Crimp the ferrules.
(14) Do Step 10.G.(13) again to assemble the other end of the shield splice.
Make sure that the shield sleeve material is pulled tightly before the ferrules are crimped.
(15) Remove the shield and the shield sleeve material that extend farther than the rear end of the
inner ferrule on each end of the shield splice.
(16) Tightly wind a layer of the tape on the splice assembly.
Make sure that the layer of tape:
• Starts at the rear end of the layer of tape on the outer jacket
• Stops at the rear end of the layer of tape on the outer jacket at the other end of the splice
• Makes a 50 percent overlap.
(17) Tightly wind a second layer of the tape on the splice assembly.
Make sure that the layer of tape:
• Starts where the first layer of tape stops
• Stops where the first layer of tape starts
• Makes a 50 percent overlap.
(18) Align the center of the sleeve with the center of the splice assembly.
(19) Shrink the sleeve into position. Refer to Subject 20-10-14.
ASSEMBLY OF SPLICES
707, 727-787
STANDARD WIRING PRACTICES MANUAL
20-30-12
Page 194
Jun 15/2021D6-54446
ECCN 9E991 BOEING PROPRIETARY - See title page for details
To Next Page
Loading...
