(21) Assemble a lacing tape wire harness tie on each end of the splice assembly approximately 0.5
inch to 0.7 inch from the end of the tape.
Refer to:
• Figure 221.
• Subject 20-10-11 for the procedure to assemble a lacing tape wire harness tie.
THE SECOND LAYER OF SILICONE TAPE ON THE SPLICE ASSEMBLY
Figure 220
ASSEMBLY OF SPLICES
707, 727-787
STANDARD WIRING PRACTICES MANUAL
20-30-12
Page 259
Jun 15/2021D6-54446
ECCN 9E991 BOEING PROPRIETARY - See title page for details
To Next Page
Loading...
