• The large solder sleeve
• The seal sleeve.
Make sure that:
• The small end of the small solder sleeve is put on the cable first
• The large end of the large solder sleeve is put on the cable first.
(5) If the splice kit does not have seal inserts and the solder sleeves are the same size put these
splice assembly components on Cable A in this sequence:
• The outer sleeve
• A solder sleeve
• The shield material
• The other solder sleeve
• The seal sleeve.
Make sure that the small end of the solder sleeve is put on the cable first.
ASSEMBLY OF BACS52P SERIES AND D-150-0300 SERIES SHIELDED SPLICE ASSEMBLIES
707, 727-787
STANDARD WIRING PRACTICES MANUAL
20-30-20
Page 154
Jun 15/2021D6-54446
ECCN 9E991 BOEING PROPRIETARY - See title page for details
To Next Page
Loading...
