Send document comments to nexus7k-feedback-doc@cisco.com
2-63
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
BGP Messages
Error Message BGP-4-PFXWARN Format: [%s] Number of prefixes received from %s reached
%d, maximum %d
Explanation The number of routes sent to us by a peer exceeded the threshold at which BGP should
generate a warning.
Parameters: Address-family, Peer, Warning limit, Max limit ...
Recommended Action Check that the peer router is configured correctly. Clear the peer if necessary
after any change.
Error Message BGP-4-SAMERID Format: Peer %s uses same routerid as us
Explanation A BGP peer is using the same router ID as this router.
Recommended Action Configure either the local or remote router with a different router ID.
Error Message BGP-4-SLAB_HOLD Format: Not able to hold element from %s slab
Explanation The system has detected an error.
Parameters: Memory slab name ...
Recommended Action No action is required.
Error Message BGP-4-SNMP_DEREGFAIL Format: Failed to deregister MIB with the SNMP
agent (%s).\n
Explanation No user action is required.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-4-SNMP_REGFAIL Format: Failed to register MIB with the SNMP agent,
the BGP MIB will be unavailable. (%s)\n
Explanation No user action is required.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-4-TXLIST Format: %s
Explanation An unexpected but recoverable event has occurred.
Parameters: Error message related to txlist ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
To Next Page
Loading...
Need help?
General
