Send document comments to nexus7k-feedback-doc@cisco.com
2-818
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
WWN Messages
Error Message WWN-2-MALLOC_ERROR: Size [dec] bytes
Explanation The WWN Manager could not allocate enough memory.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message WWN-2-PSS_BKP_PSS_MISMATCH: Block [dec]: PSS: Not Free; BKPLN PROM:
Free
Explanation This WWN Manager detected a discrepancy between the information on the chassis and
that in its persistent information databases. The persistent information database has been updated
with the information on the chassis.
Recommended Action No action is required.
Error Message WWN-2-PSS_ERROR: [chars]
Explanation The WWN Manager has detected an error while operating on a persistent storage
database.
Recommended Action No action is required.
Error Message WWN-2-STDOUT_ROTATE_FAILURE: Failed to rotate stdout file: [chars]
Explanation The WWN Manager has failed to rotate its current stdout file with filename [str.]. The
filesize could grow beyond its maximum limit.
Recommended Action No action is required.
Error Message WWN-2-TYPE1_CRIT: [dec] (< [dec] %) Remain
Explanation The WWN Manager has only [dec] or less than [dec]-percent WWNs remaining.
Recommended Action Please add additional WWNs by programming a new Secondary MAC address
and its range.
Error Message WWN-2-TYPES2_5_CRIT: [dec] (< [dec] %) Remain
Explanation The WWN Manager has only [dec] or less than [dec]-percent WWNs of NAA Types 2
and 5 remaining.
Recommended Action Please add additional WWNs by programming a new Secondary MAC address
and its range.
To Next Page
Loading...
Need help?
General
