Send document comments to nexus7k-feedback-doc@cisco.com
2-162
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
ETH_PORT_CHANNEL Messages
ETH_PORT_CHANNEL-5
Error Message ETH_PORT_CHANNEL-5-AUTO_CREATE_FAILURE: [chars] [chars]
Explanation Auto create process on the port failed.
Recommended Action No action is required.
Error Message ETH_PORT_CHANNEL-5-CREATED: [chars] created
Explanation A port channel is created.
Recommended Action No action is required.
Error Message ETH_PORT_CHANNEL-5-DELETED: [chars] deleted
Explanation A port channel is deleted.
Recommended Action No action is required.
Error Message ETH_PORT_CHANNEL-5-FOP_CHANGED: [chars]: first operational port
changed from [chars] to [chars]
Explanation The first operational port in a port channel is changed.
Recommended Action No action is required.
Error Message ETH_PORT_CHANNEL-5-IF_DOWN_SUSPENDED_BY_MODE: Interface [chars] is
down (Suspended due to incompatible mode
Explanation Compatibility check failed when adding ports to port channel.
Recommended Action Make sure the compatibility parameters are consistent between the ports and
the port channel.
Error Message ETH_PORT_CHANNEL-5-IF_DOWN_SUSPENDED_BY_SPEED: Interface [chars] is
down (Suspended due to incompatible speed
Explanation Operational compatibility check failed on the port in a port channel.
Recommended Action Make sure the compatibility parameters are consistent between the ports and
the port channel.
To Next Page
Loading...
