Send document comments to nexus7k-feedback-doc@cisco.com
2-62
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
BGP Messages
Error Message BGP-4-MQUNEXPECT Format: Recieved unexpected message (%d/%d) on %s
queue
Explanation An unexpected but recoverable event has occurred.
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-4-MTSNOMSG Format: No MTS payload found on %s queue, opc %d
Explanation An unexpected but recoverable event has occurred.
Parameters: Queue name, MTS Opcode ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-4-MTSUNKOPC Format: Recieved unknown MTS message on %s queue, opc
%d
Explanation An unexpected but recoverable event has occurred.
Parameters: Queue name, MTS Opcode ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message BGP-4-NODAMPMEM Format: [%s] Unable to dampen prefix %s/%d from peer
%s due to no memory
Explanation BGP_EXPL_NO_MEMORY
Parameters: Address-family, Prefix/masklength, Peer address ...
Recommended Action No action is required.
Error Message BGP-4-NORID Format: Peer %s sent us 0.0.0.0 as its router-id
Explanation A BGP peer sent us an invalid router ID.
Recommended Action Check that the peer router is configured correctly. Clear the peer if necessary
after any change.
Error Message BGP-4-PFXEXCEED Format: [%s] No. of prefix received from %s exceeded
configured limit %d
Explanation A peer sent more routes than BGP was configured to accept.
Parameters: Address-family, Peer, Prefix limit ...
Recommended Action Check that the peer router is configured correctly. Clear the peer if necessary
after any change.
To Next Page
Loading...
Need help?
General
