Send document comments to nexus7k-feedback-doc@cisco.com
2-471
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
PIXM Messages
PIXM Messages
This section contains the PIXM messages.
PIXM-2
Error Message PIXM-2-PIXM_CRIT: [chars]
Explanation PIXM or other application had critical error.
Recommended Action No action is required.
PIXM-3
Error Message PIXM-3-PIXM_ERR: [chars]
Explanation PIXM or other application had some error.
Recommended Action No action is required.
Error Message PIXM-3-PIXM_FAILURE: PIXM / PIXMC ERROR, [chars]
Explanation PIXMC or other application did not respond with a time limit or something bad
happened.
Recommended Action No action is required.
Error Message PIXM-3-PIXM_SYSLOG_UPGRADE_OVER: [chars]
Explanation PIXM received UPGRADE_OVER before receiving UPGRADE_READY for
slot:[dec].
Recommended Action No action is required.
PIXM-4
Error Message PIXM-4-PIXM_SEND_FAILURE: PIXM SEND FAILURE, [chars]
Explanation PIXM was not able to send to PIXMC or other application.
Recommended Action No action is required.
To Next Page
Loading...
