Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-71
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
CALLHOME Messages
BOOTVAR-6
Error Message BOOTVAR-6-ALREADY_IN_SYNC: Image already in sync
Explanation This message indicates that you do not need to update the image on the standby
supervisor module.
Recommended Action No action is required.
Error Message BOOTVAR-6-CONFIG_UPDATED: Boot configuration updated
Explanation The boot-loader configuration files have been successfully updated.
Recommended Action No action is required.
Error Message BOOTVAR-6-STARTING: Boot configuration initialized
Explanation The service has successfully started.
Recommended Action No action is required.
CALLHOME Messages
This section contains the CALLHOME messages.
CALLHOME-2
Error Message CALLHOME-2-EVENT: [chars]
Explanation A Call Home event [chars] occurred.
Recommended Action If you have configured your e-mail address to receive Call Home notifications,
check your e-mail for more details about this Call Home event. If Call Home was not enabled,
execute commands relevant to the callhome event to get more information about the error.
Error Message CALLHOME-2-PROGRAM_EXIT: callhome process ending: [chars]
Explanation A Call Home process is exiting with the reason [chars].
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English