Cisco AP775A - Nexus Converged Network Switch 5010 Reference

Send document comments to nexus7k-feedback-doc@cisco.com
2-774
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
URIB Messages
Error Message URIB-4-UFDM_ACKNOT_FOUND Format: Could not find UFDM buffer with ptr
0x%08x
Explanation Ack received for a UFDM buffer that URIB does not know about.
Parameters: Memory address of UFDM buffer ...
Recommended Action No action is required.
Error Message URIB-4-UNEXPECTED_MESSAGE Format: %s %d
Explanation An unexpected interprocess message was received.
Recommended Action No action is required.
Error Message URIB-4-UNEXPECTED_VALUE Format: Unexpected value for %s
Explanation An unexpected value was encountered for the logged event.
Recommended Action No action is required.
Error Message URIB-4-ZERO_NEXTHOP Format: Client \%s\ added 0.0.0.0 next hop and
interface %s is not point-to-point
Explanation The client protocol added a 0.0.0.0 next-hop address on a nonpoint-to-point interface
Parameters: Client, Interface ...
Recommended Action No action is required.
URIB-5
Error Message URIB-5-API_INIT_SEM_CLEAR Format: Cleared the API semaphore from %d
Explanation The API semaphore was in an unexpected state, and was restored to a correct value.
Parameters: Value of semaphore ...
Recommended Action No action is required.
Error Message URIB-5-BOGUS_INTF Format: Client \%s\ tried to add %s/%d via %s with
invalid iod %d
Explanation A bad interface was received in a path add from the client.
Parameters: Client, Prefix, Prefix Length, Next-hop, Iod ...
Recommended Action Use the 'restart' command to restart the feature and clear this problem.

Cisco AP775A - Nexus Converged Network Switch 5010 Specifications

General

Brand	Cisco
Model	AP775A - Nexus Converged Network Switch 5010
Category	Switch
Language	English