Send document comments to nexus7k-feedback-doc@cisco.com
2-429
Cisco NX-OS System Messages Reference
OL-15994-03
Chapter 2 System Messages and Recovery Procedures
OSPF Messages
Error Message OSPF-1-MQSEND Format: Unable to send message %s to %s
Explanation An internal software error occurred.
Parameters: Message, Destination ...
Recommended Action Use the 'restart' command to restart the feature and clear this problem.
Error Message OSPF-1-NOMEM Format: Malloc (%ld bytes) failed for: %s
Explanation The router did not have enough memory to store mentioned data structures.
Parameters: Size, Error ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message OSPF-1-SLABS Format: Could not create %s slabs
Explanation The router did not have enough memory to reserve space in advance for certain slab
data structures.
Parameters: Slab Type ...
Recommended Action Contact the Cisco Technical Assistance Center (TAC) through the Cisco
Support web site http://www.cisco.com/tac.
Error Message OSPF-1-STARTTHREAD Format: Unable to start thread %s (%d), error %s
Explanation An internal software error occurred.
Parameters: Thread name, Thread Id, Error ...
Recommended Action Use the 'restart' command to restart the feature and clear this problem.
Error Message OSPF-1-TAG Format: Unable to retrieve service tag on %s supervisor
Explanation An internal software error occurred.
Parameters: Active or Standby Supervisor ...
Recommended Action Use the 'restart' command to restart the feature and clear this problem.
Error Message OSPF-1-TIMER Format: Unable to create %s timer on interface %s
Explanation An internal software error occurred.
Parameters: Timer, Interface Id ...
Recommended Action Use the 'restart' command to restart the feature and clear this problem.
To Next Page
Loading...
Need help?
General
